Download  Print this page

Mitsubishi Electric MCCH1 Installation Manual page 3

Portable central controller and outdoor air sensor
Hide thumbs

Advertisement

Link Portable central controller to RedLINK™ network
WIRELESS SETUP
Press to link
another receiver
YES
CONNECT MORE?
Link outdoor sensor to RedLINK™ network
Press and release
Français : voir la page 7 • Español: vea la página 13
CONNECT
M28481
Press to save
and exit
NO
M28482
M28483
1 Make sure the CONNECT light on the wireless
receiver is flashing.
CONNECT
2 Press
at the Portable central
controller. There will be a short delay as the
Portable central controller seeks a signal from
the wireless network.
3 When the screen displays "Connected," press
DONE
.
NO
4 Press
at the next screen to save and exit.
YES
(Or press
and repeat steps 1-4 to link
another receiver.)
If E1 appears, see error codes on page 4.
The linking procedure may time out if there is no
keypress within 15 minutes. To begin again, press
and hold the blank space (or arrow, if present)
in the lower right corner of the screen until the
display changes (about 3 seconds).
1 Make sure the CONNECT light on the wireless
receiver is flashing.
2 Press and release the
back of the sensor.
3 Check remote controller to verify that the
outdoor sensor is working. After about 15
seconds, the remote controller should display
outdoor temperature and humidity.
3
CONNECT
button on the
69-2428EFS—03

Advertisement

loading

  Also See for Mitsubishi Electric MCCH1

  Related Manuals for Mitsubishi Electric MCCH1

This manual is also suitable for:

Mos1