Print Paper Selection Mode (Fax); Standard Mode; Width Preference Mode - Konica Minolta bizhub 200 Service Manual

Theory of Operation Ver. 1.0 Aug. 2005
5.3

Print Paper Selection Mode (FAX)

• This system has the following modes for selecting print paper. The soft switch (MODE
008) toggles these modes.
• They are valid only for printing received documents.
5.3.1

Standard mode

• This mode selects print paper to avoid document splitting as much as possible.
Example: Metric area
Available sizes of paper: A4 Lengthwise and A3 Lengthwise
Size of received document
Printing mode
• In this case, the system will use the A3 paper without reduction. If the A3 paper has run
out, the A4 Lengthwise paper will be used with reduction.
Example: Inch area
Available sizes of paper: Letter Lengthwise and 11 x 17 Lengthwise
Size of received document
Printing mode
• In this case, the system will use the Letter paper without reduction. If the Letter Length-
wise paper is run out, the 11 x 17 Lengthwise paper will be used with reduction.
5.3.2

Width preference mode

• This mode selects paper whose width is the same as or smaller than a received docu-
ment.
Example: Metric area
Available sizes of print paper: A4 Lengthwise and A3 Lengthwise
Size of received document
Printing mode
• In this case, the system will use the A3 paper with reduction. If the A3 paper has run out,
the printing job will be halted and wait for new paper.
Example: Inch area
Available sizes of print paper: 11 x 17 Lengthwise
Size of received document
Printing mode
• In this case, the system will not print. If the Letter L paper is run out, the printing job will
be halted and wait for new paper.
B4 Lengthwise
Automatic reduction (Upper reduction limit of 65 %)
Letter Lengthwise
Automatic reduction (Upper reduction limit of 60 %)
B4 Lengthwise
Automatic reduction (Upper reduction limit of 60 %)
Letter Lengthwise
Automatic reduction (Upper reduction limit of 60 %)
5. Selecting Print Paper
27