Dell NSA E5500 Getting Started Manual page 43

Associating Pre-Registered Appliances
To associate two already-registered Dell SonicWALL security
appliances so that they can use HA license synchronization,
perform the following steps:
1. Login to MySonicWALL.
2. In the left navigation bar, click My Products.
3. On the My Products page, under Registered Products,
scroll down to find the appliance that you want to use as
the parent, or primary, unit. Click the product name or
serial number.
4. On the Service Management - Associated Products page,
scroll down to the Associated Products section.
5. Under Associated Products, click HF Secondary.
6. On the My Product - Associated Products page, in the text
boxes under Associate New Products, type the serial
number and the friendly name of the appliance that you
want to associate as the child/secondary/backup unit.
7. Select the group from the Product Group drop-down list.
The product group setting specifies the mysonicwall users
who can upgrade or modify the appliance.
8. Click Register.
If You Are Following
Scenario...
B - NAT with State Sync Pair
43 | Configuring L2 Bridge Mode
Proceed to Section:
Additional Deployment Configuration -
page 46
Configuring L2 Bridge Mode
This section provides instructions to configure the Dell
SonicWALL NSA E5500 appliance in tandem with an existing
Internet gateway device. This section is relevant to users
following deployment Scenario C.
This section contains the following sub-sections:
• Connection Overview - page 43
• Configuring the Primary Bridge Interface
• Configuring the Secondary Bridge Interface
Connection Overview
Connect the X1 port on your Dell SonicWALL NSA E5500 to the
LAN port on your existing Internet gateway device. Then
connect the X0 port on your E5500 to your LAN.
- page 44
- page 44