Resetting The Recorder - JVC LVT2013-001A Instructions Manual

Symptom
The disc was recorded in Video mode.
Can't play disc recorded
on this Recorder on
Some players will not play even a
another DVD player.
finalized disc recorded in Video mode.
The disc was recorded in VR mode.
Discs recorded with copy-once materi-
al cannot be played on other players.
The remaining blank space on the
Cannot record or did
disc is insufficient.
not record successfully.
The source you are trying to record is
copy-protected.
When recording to a Video mode disc,
programs that are copy-once protect-
ed cannot be recorded.
Stereo Audio Record TV is not Stereo-compatible.
and/or Playback not
Recorder A/V Out jacks are not
present.
connected to TV A/V In jacks.
Recorder Audio/Video Out is not
selected for viewing at the TV.

Resetting the Recorder

If you observe any of the following symptoms...
• When the Recorder is plugged in, but the
power will not turn on or off.
• When the display window is not working.
• When the Recorder does not operate
normally.
Cause
.
You can reset the Recorder as follows:
• Press and hold the STANDBY/ON button for
more than five seconds. This will force the
Recorder to power off.
Press the STANDBY/ON button again to turn
the Recorder back on.
• Unplug the power cord and then plug the
power cord again after more than five sec-
onds.
Correction
Finalize the disc; see page 18.
No solution.
The other player must be RW
compatible in order to play it.
No solution.
Use another disc.
You cannot record the source.
Use a VR mode formatted disc for
copy-once material.
No solution.
Make A/V connections. Stereo is avail-
able only via A/V output from Recorder.
Select AUX or A/V source as TV input.
45