JVC 0503-AH-ID-JVE Instructions Manual page 98

98
EN
TIMER RECORDING (cont.)
SYMPTOM
#
5. " " blinks for 10 seconds and the
Timer mode is disengaged.
6. The S V system does not
HOW IEW
timer-record properly.
$
7. " " and " " on the front display
panel won't stop blinking.
N $
8. " ", " " and " " on the front
display panel won't stop blinking.
OTHER PROBLEMS
SYMPTOM
1. Whistling or howling is heard from
the TV during camcorder
recording.
2. When scanning channels, some of
them are skipped over.
3. The channel cannot be changed.
4. Channel settings that were made
manually seem to have changed or
disappeared.
5. No channels are stored in the
recorder's memory.
6. The remote control won't operate
the TV or satellite receiver.
7. A programme that has a title
"Found 001" is recorded
unexpectedly on the HDD deck.
POSSIBLE CAUSE
#
has been pressed when there are
no programs in memory.
The recorder's channel positions
have been set incorrectly.
The end of the tape was reached
during Instant Timer Recording.
The loaded cassette has had its
record safety tab removed.
The end of the tape was reached
during Automatic Satellite
Programme Recording.
POSSIBLE CAUSE
The camcorder's microphone is too
close to the TV.
The TV's volume is too high.
Those channels have been
designated to be skipped.
Recording is in progress.
After the manual settings were
made, Auto Channel Set was
performed.
The TV aerial cable was not
connected to the recorder when
Auto Set Up was performed.
The fully-wired 21-pin SCART cable
was not connected between TV and
the recorder when Preset
Download was performed.
The remote control brand setting is
incorrect.
The power was cut off because of a
power failure, etc. while the
recorder was working.
TROUBLESHOOTING (cont.)
CORRECTIVE ACTION
Check the programmed data and re-
program as necessary, then press
again.
Refer to "Guide Program Number
Set" ( pg. 85) and re-perform the
procedure.
The programme may not have been
recorded in its entirety. Next time
make sure you have enough time on
the tape to record the entire
programme.
Remove the cassette and cover the
hole with adhesive tape, or insert a
cassette with the record safety tab
intact.
The programme may not have been
recorded in its entirety. Next time
make sure you have enough time on
the tape to record the entire
programme.
CORRECTIVE ACTION
Position the camcorder so its
microphone is away from the TV.
Turn the TV's volume down.
If you need the skipped channels,
restore them ( pg. 90).
9
Press to pause the recording,
change channels, then press
resume recording.
Perform manual setting again.
Turn off the recorder once and
connect the TV aerial cable to the
recorder properly, then turn on the
recorder again. Then perform Auto
Set Up again. ( pg. 14)
Turn off the recorder once and
connect the fully-wired 21-pin
SCART cable to the recorder properly,
then turn on the recorder again. Then
perform Preset Download again.
( pg. 16)
Re-set the remote control to the
correct brand. ( pg. 53, 54)
Delete the "Found 001" programme.
( pg. 58)
#
4
to