Installation and connection
The washing machine is programmed
to cold water at the time of delivery. To
run the machine with hot water, it needs
to be reprogrammed. This is described
under section "Settings menu".
The washing machine must always
be connected to the mains water
supply (inlet hose with blue dots).
Cold water connection (mains water
supply)
The inlet hose with blue dots is used for
mains water connection.
Hot water connection
The inlet hose with red dots is used for
connection to the hot water supply.
66
Useful hints when connecting to the hot
and cold water supply.
– The maximum temperature at the tap
must not exceed 60°C. The ideal
temperature is 55°C.
– When connected to the hot (and
cold) water supply, after some time
the washing machine will switch over
to the mains (cold) water supply if no
hot water is being supplied.
However, this can lead to a poor
washing result.
The conditions for connection are
described in the preceding pages.
This appliance incorporates
backflow protection complying with
ATS 5200.101.
No further backflow protection
required for connection to the water
supply.