JVC 0504CSH-ID-VT Instructions Manual page 25

G
Return to the normal screen.
Press PROG or OK. "PROGRAM COMPLETED" appears
on the TV screen for about 5 seconds, then the normal
screen appears.
Repeat steps B – G for each additional programme.
H
Engage the unit's timer mode.
Press #. The unit turns off automatically and "#"
appears on the front display panel.
To disengage the timer mode, press # again.
NOTES:
To Change The Stop Time:
— press STOP +/– after pressing OK in step D. You can
compensate for anticipated programme schedule delays.
To Timer-Record Weekly Or Daily Serials:
— after pressing OK in step D, press WEEKLY (number key
"9") for weekly serials or DAILY (number key "8") for daily
serials (Monday — Friday). Either "WEEKLY" or "DAILY"
appears on the TV screen. Pressing the button again makes the
corresponding indication disappear.
You can programme this unit to timer-record as many as 8
programmes. If you try to programme the unit to record a
ninth, "PROGRAM FULL" appears on the TV screen and
"FULL" appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes. ( pg. 27)
If there is a conflict in the timer schedule and one programme
overlaps with another, the programme starting earlier or
programme with the lower programme number will be
recorded.
Satellite Receiver Users
To timer-record a satellite broadcast using the S
system:
A Set "L-2 SELECT" to "A/V". (
B Perform steps A – H.
C Set the satellite receiver to the appropriate channel before
the selected programme begins.
D Leave the satellite receiver's power on.
V
HOW IEW
pg. 64)
VPS/PDC Recording
Now available from some TV stations, PDC (Programme
Delivery Control) and VPS (Video Programme System) are
service designed to assure safe, accurate timer recording.
With this system, special code signals are transmitted
together with the audio/video signals. These code signals
control your unit and have precedence over the advertised
times you may have preset into the timer. This means that
your unit will start and stop recording when the preset TV
programmes actually start and end — even if the broadcast
time of a preset TV programme is changed.
NOTES:
When you use Express Timer Programming, set the start
time (VPS or PDC time) exactly as advertised in the TV
listing. A different time than advertised will result in no
recording.
VPS/PDC recording is also possible when a satellite
receiver or a cable system is connected to L-2 IN/
DECODER connector on your unit.
VPS/PDC recording is also possible via the L-1 IN/OUT
connector.
How to check if the station being received transmits a
VPS/PDC signal
A Press – –:– – until the channel position appears on the
front display panel.
B Hold down START + for about 5 seconds.
"VPS/PDC" appears blinking on the TV screen.
If a VPS/PDC signal is detected from the station,
"VPS/PDC" will stop blinking.
If no VPS/PDC signal is detected from the station,
"VPS/PDC" will blink at a slower rate.
C Press – –:– – or START + again to return to normal display.
25
EN