Audio Dubbing (DV Deck Only)
This function allows you to record new audio, without erasing the
original audio, on a DV tape that was recorded with ADV AUDIO
RECB set to A12BITB (A pg. 71).
You cannot perform Audio Dubbing on a tape that was recorded
with ADV AUDIO RECB set to A16BITB (A pg. 71), on a tape that
was recorded at the ALPB speed, or on a blank tape.
CD player, etc.
CD player, etc.
Slide the TV/CABLE/DBS/DVD switch to DVD.
Connect an audio device to the unit's [AUDIO] input connectors
on the front panel.
When using a monaural audio device, connect its AUDIO OUT
connector to the [AUDIO-L] input connector on your unit.
Load a Mini DV cassette with the erase protection switch set to
Press DV/HDD/DVD SELECT on the unit repeatedly or DV on
the remote control so that the DV lamp lights up on the unit.
Press CH +/– to select AF-1B.
Start playback slightly before the actual point from where you
wish to start dubbing.
Press W to pause playback.
Press A.DUB to engage the audio dubbing mode.
Your unit enters the Audio Dubbing Pause mode.
To perform Audio Dubbing with audio mixing, press AUDIO to
select AL+RB at this point. When using the DV deck as the
recording deck, also make sure that AAUDIO MODEB is set to
ASOUND1B (A pg. 71).
* Audio Dubbing with audio mixing is not possible if you are using a
monaural audio component, or if you don't have an audio mixer.
Engage the audio device's playback, then press I to start the
tape in the unit. Audio dubbing starts at this point.
To stop dubbing temporarily, press W. Press I to resume
Press o on the unit, then stop playback on the audio device to
end the audio dubbing.
Once the Audio Dubbing starts, you cannot use the other deck.
When monitoring the audio dubbed sound on the DV deck, set
AAUDIO MODEB to ASOUND2B (A pg. 71).
When playing back an audio dubbed Mini DV tape on the DV
deck, set AAUDIO MODEB to ASOUND2B (A pg. 71).
Audio dubbing is not possible using the [DV IN/OUT] connector.
Audio dubbing is not possible on a blank portion of the tape.