Download Print this page

HP Designjet T1100 Service Manual: Error Messages For The Touch Screen

Scanner series.
Hide thumbs

Advertisement

Error Messages for the Touch Screen

FP Message:
Problem
Description:
Corrective Action: Reboot the system and enter the BIOS setting. Load "Setup Default" and save
FP Message:
Problem
Description:
Corrective Action: Replace the CMOS Battery.
FP Message:
Problem
Description:
Corrective Action: Reboot the system and enter the BIOS setting. Load "Setup Default" and save
FP Message:
Problem
Description:
Corrective Action: Connect the Touch Screen to a CRT Monitor and check the resolution setting
FP Message:
Problem
Description:
Corrective Action: Try the following:
HP Designjet T1100 MFP, 4500mfp, 4500 Scanner, 820 MFP Service Manual
Introduction
This set of number system error codes refers to the systems and parts relating
to the Touch Screen.
BIOS ROM checksum error - system halted
Error during initialization.
the BIOS setting.
CMOS battery failed
The battery life is approximately 3 years before it requires replacement.
CMOS checksum error - defaults loaded
Error detected in the CMOS.
the BIOS setting.
Display switch is set incorrectly
Problem found with the Touch Screen.
for the display. If the CRT Monitor is working well then it seems there is an
LCD problem. Return the Panel PC to Repair Center for further tests.
Hard Disk install failure
No Hard Disk detected, error related to Hard Disk Drive.
In the BIOS setup select Standard CMOS Features and check if the IDE
detection method is set to AUTO (password to access the BIOS is bigcoco)?
– If Yes: In Advanced BIOS features, set HDD to first boot device.
– If No: Choose auto for all IDE detection.
Check if HDD can be detected in the boot-up system configuration table:
– If Yes: check the boot up files in HDD, recover it if necessary.
System Error Codes
2-39

Advertisement

Table Of Contents

Troubleshooting

   Related Manuals for HP Designjet T1100

This manual also for:

4500mfp, 4500, 820 mfp

Comments to this Manuals

Symbols: 0
Latest comments: