Download Print this page

HP Designjet T1100 Service Manual: Ddr Dram Failure; Dvd-rom Failure; The Cd/dvd Is Stuck In The Dvd-rom And Cannot Be Ejected Out

Scanner series.
Hide thumbs

Advertisement

HP Designjet T1100 MFP, 4500mfp, 4500 Scanner, 820 MFP Service Manual
The HDD failure:
The HDD is running, and the system configuration has identified the HDD's
ID while booting up. Try the following:
Set the type of hard disk to AUTO in STANDARD CMOS SETUP.
Reconnect the cable between HDD and main board.
Change the HDD ⇒ Page 4-91.
The HDD is not running, and the system configuration can not identify the
HDD's ID while booting up. Try the following:
Reconnect the cable between HDD and main board.
Change the cable between HDD and main board.
Change HDD ⇒ Page 4-91.

DDR DRAM failure:

If the computer repeatedly makes a long beep, and the display is blank
when you power on, this indicates a DDR DRAM error, replace the DDR
DRAM ⇒ Page 4-88.

DVD-ROM failure:

The DVD-ROM indicator light is on when you switch on. Try the following:
Check the possible damage on the cable between DVD-ROM and main
board.
The DVD-ROM indicator light is off when power up and the screen show
no message of any DVD-ROM installed.
Check for DVD-ROM auto detection in the BIOS setup:
Procedure to do this: In the BIOS setup, select standard CMOS features,
set all IDE detections ( ie Primary master, Primary slave ,secondary
master, secondary slave ) to AUTO
Reconnect the cable between DVD-ROM and main board.
Replace the DVD-ROM ⇒ Page 4-89.
The CD/DVD is stuck in the DVD-ROM and cannot be ejected
out.
Push a pin into the hole at the right side of the DVD-ROM eject button.
Troubleshooting
1-31

Advertisement

Chapters

Troubleshooting

   Related Manuals for HP Designjet T1100

This manual also for:

4500mfp, 4500, 820 mfp

Comments to this Manuals

Symbols: 0
Latest comments: