Furuno FM-8900S Installation Manual page 34

4. INITIAL SETTINGS
4.7.2 VHF antenna only
Non-GMDSS vessels are not required to have DSC functionality and thus a DSC antenna is
unnecessary. If this is the case do as shown below to use only the VHF antenna.
Remove the outer cover and the shield cover to show the TRX_WR Board (05P0841).Connect the
supplied mini-pin assy. as shown below.
mini-pin from J2. mini-pin from J2.
1. Disconnect the mini-pin from J2.
Disconnect Disconnect
Tape cable Tape cable
with vinyl with vinyl
2. Connect the supplied mini-pin assy.
between J2 and J3. Use vinyl tape to
attach the cable disconnected at step 1
to the chassis or the W9 connector assy.
28
Connect Connect
mini-pin mini-pin
between between
J2 and J3. J2 and J3.
tape. tape.