Immobilizer System (Equipped Models)
The registered ignition key is successfully registered in
The red warning indicator light (LED) and the immobilizer
warning symbol [A] blink 1 time and stop for 1 second and
then repeat this cycle.
Turn to OFF the ignition switch and remove the registered
The immobilizer warning symbol [B] disappears.
The red warning indicator light (LED) [A] then blinks for 15
seconds; it means the ECU is in the registration mode.
After 15 seconds, the ECU ends the registration mode
and stops blinking the red warning indicator light (LED).
Insert and turn on the next key between 15 seconds that
the ECU is in the registration mode.
When a registration mode was ended, do the registered
ignition key verification procedure over again to restart
it. This applies to all ignition key registration.
Insert the other remaining registered ignition key into the
ignition switch, and turn it to ON.
Keep other ignition keys away from the immobilizer an-
If there is any problem in the registration, the red warning
indicator light (LED) and the immobilizer warning symbol
[A] blink to display the collation error.
Immobilizer Amplifier Failure
When Registered Ignition Key is Inserted.
ELECTRICAL SYSTEM 16-95