16-90 ELECTRICAL SYSTEM
Immobilizer System (Equipped Models)
Case 2: When the ignition switch is faulty and has to
Prepare a new ignition switch [A] and two new ignition
These parts are available as a set. Prepare the current
registered ignition key [C].
Ignition Switch (see Immobilizer System Parts Replace-
Seat (see Seat Removal in the Frame chapter)
Remove the immobilizer/Kawasaki diagnostic system
Connect the key registration adapter [A] and key registra-
tion unit [B].
Special Tools - Key Registration Unit: 57001-1582
Key Registration Adapter: 57001-1746
New Ignition Switch Lead Connector [A]
Immobilizer Antenna Lead Connector [B] (of Current Ig-
Keep the antenna [C] more than 15 cm (5.9 in.) from
the new ignition switch [D].
Insert the current registered ignition key [A] into the cur-
rent ignition switch [B].
Insert the new ignition key 1 [C] into the new ignition
switch [D], and turn it to ON.
The red warning indicator light (LED) and the immobilizer
warning symbol [A] blink to display the ECU is in the reg-
istration mode (go to the next step).