Mounting; Adjusting The Sunshield; Accessing The Inside Of The Housing Enclosure - Siemens CHSL4010 Installation Manual

Large camera housing
Table of Contents

Advertisement

5

Mounting

5.1

Adjusting the Sunshield

5.2

Accessing the inside of the Housing Enclosure

Siemens Building Technologies
Fire Safety & Security Products
1.
Firmly squeeze (A) the sides of the sunshield (See Fig. 3).
2.
Slide (B) the sunshield to the required position.
3.
Release the sunshield and it will remain in position.
Fig. 3
Sunshield adjustment
1.
Using the ALLEN key provided, loosen but do not completely remove the
4 securing screws (A) (See Fig. 4).
2.
Slide the housing cover forwards (B).
3.
Disconnect the earth wire from the terminal board (C).
4.
Allow the cover to pivot at the end or twist to completely remove (D).
NOTE
To re-assemble carry out steps 1 to 4 in reverse, making sure the earth wire is reconnected. The
screws which secure the housing to the rear cap should be retightened to a torque of 2 Nm.
Fig. 4
Inside the housing enclosure
1
Rear End Cap
Mounting
11
09.2008

Advertisement

Table of Contents
loading

This manual is also suitable for:

Chsl4011

Table of Contents