Troubleshooting - JVC LVT2008-001B Instructions Manual

Jvc dvd player instruction manual
Table of Contents

Advertisement

Troubleshooting

Symptom
• The power cord is disconnected.
No power.
• No disc is inserted.
The power is on, but
the DVD player does
not work.
No picture.
• Your TV does not accept the
• The TV is not set to receive DVD
• The video cable is not connected
• The equipment connected with the
No sound.
• The power of the equipment
• The AUDIO options are set to the
• An unplayable disc is inserted.
The DVD player does
not start playback.
• The remote control is not pointed at
The remote control
does not work properly.
• The remote control is too far from the
• The current remote control code does
Possible Cause
resolution that you set on the unit.
signal output.
securely.
audio cable is not set to receive DVD
signal output.
connected with the audio cable is
turned off.
wrong position.
the remote sensor on the DVD player.
DVD player.
not match the unit.
Correction
• Plug the power cord into the wall outlet
securely.
• Insert a disc. (Check the disc indicator
in the display window is lit.)
• Please read TV's owner's manual then
use RESOLUTION button to set the
resolution that your TV can accept.
• Select the appropriate video input
mode on the TV.
• Connect the video cable securely.
• Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD player.
• Turn on the equipment connected with
the audio cable.
• Set the AUDIO option to the correct
position, then turn on the DVD player
again by pressing STANDBY/ON.
• Insert a playable disc. (Check the disc
type and regional code.)
• Point the remote control at the remote
sensor of the DVD player.
• Operate the remote control closer to
the DVD player.
• Identify the remote control code with
the code of unit. (See page 24).
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xv-n682sN680b - xv dvd playerXv-n680b

Table of Contents