To Connect To An Amplifier/Receiver Equipped With Dolby Digital 5.1-Channel Inputs - JVC LET0141-002A Instructions Manual

To connect to an amplifier/receiver equipped with Dolby Digital 5.1-channel inputs

The Dolby Digital decoder is built in the unit, so you can enjoy the Dolby digital surround sound without the need of
an external decoder.
Connect the unit's 5.1-channel outputs to the Dolby Digital 5.1-channel inputs of an amplifier or receiver using the
supplied audio cables.
The unit
VIDEO OUT
VIDEO S-VIDEO Y P P
B R
COMPONENT
FRONT REAR CENTER
LEFT
RIGHT
SUBWOOFER
ANALOG
AUDIO OUT
Audio cable (supplied)
Audio/video cable (supplied)
Audio cable (supplied)
• Be sure to connect correctly between corresponding terminals. The order of the 5.1-channel terminals depend on
units.
• An Audio/video cable is recommended for connection to the FRONT terminal (Yellow jack (for Video Signal) is not
used in this connection).
NOTE
¶
When using the 5.1-channel outputs of the unit, set the "DOWN MIX" in the "PREFERENCE 2" on-screen display
to "OFF" and select "5.1 CHANNEL" or "EXPERT" in the "SPK.SETTING" on-screen display. If the "EXPERT" is
selected, you can control the audio output balance of the speakers (see pages 57 and 60).
AV COMPU LINK
PCM/STREAM
OPTICAL COAXIAL
DIGITAL
Yellow
Amplifier or receiver
CENTER
White
SUBWOOFER
Red
FRONT
White
AUDIO IN
LEFT
RIGHT
Red
REAR
White
LEFT
RIGHT
Red
Getting started
English
Français
19