Pump Accessory - Maytag Neptune MAH3000 Service Manual

Figure 6-6
CLEANING THE PUMP
The pump assembly can also be disassembled
without removing the hoses from the pump
(See Figure 6-6).
1 . Depress the locking tab on the face of the
pump housing.
2 . Rotate the block portion of the pump con-
taining the motor windings toward the
front of the washer. This will disengage
the locking tabs of the pump housing from
the pump face.
3 . Carefully remove the pump body away
from the housing. The drain impeller is
exposed for cleaning.
Pump Accessory Kit
1 . Disconnect power to the unit.
2 . Disconnect the drain hose from the exist-
ing pump in the washer.
3 . Attach the accessory connector to the
pump drain outlet and secure with the
clamp found in the kit.
16008373-01
4 . Position the second pump near the first
pump and connect the accessory connec-
tor to the sump intake of the second pump.
Secure with the clamp in the kit.
5 . Connect the drain hose to the drain outlet
of the second pump. Secure with a clamp.
6 . The second pump assembly is not secured
to the washer's base frame.
7 . Installation is complete.
SECTION 6. WATER CARRYING COMPONENTS
© 1998 Maytag Corporation
Figure 6-7
Figure 6-8
6-5