Dispenser Assembly - Maytag Neptune MAH3000 Service Manual

5. Pull the air dome and hose out through the
sump opening in the spin basket (Figure
6 - 3 ) .
REPLACEMENT/ROUTING
1 . Thread the narrow end of the hose through
the air dome outlet in the rear of the outer
tub (Figure 6-3). Apply alcohol to lubri-
cate the hose to ease insertion into the
outer tub air dome outlet.
NOTE: Using soap and water may lead to a
potential leak.
Spin Basket
S u m p
Opening
Exposed
Air Dome
Outlet
Figure 6-3
2 . Secure the retainer clip on the outside
ridge of the air dome hose.
3 . Push the bent end of the air dome down
into the sump area, below the spin basket,
making sure the flat rubber tab on the air
dome is down inside the drain sump
opening.
4 . The air dome hose is retained to the
rear wall of the cabinet with two clips.
NOTE: A silver indicator mark is located
approximately 20 inches away from the air
dome. The indicator mark must be located
under the lower clip to allow the correct
amount of slack in the hose.
16008373-01
5 . Remove all slack in the hose between the
6 . Route the air dome hose into the center

DISPENSER ASSEMBLY

The dispenser assembly is located in the left
hand side of the top cover. Three bays dis-
pense the fabric softener, bleach and deter-
gent into the wash load. A double wax motor
mechanism directs the flow of water into each
specific bay when required for disbursement
into the wash load. When a specific fluid is
required, the water is directed into that bay.
As water fills the bay, the fluid level rises.
When the fluid reaches a specific height, it is
siphoned out into the dispenser injector hose
Rear
Baffle
to the wash load.
Removed
R E M O V A L
1 . Disconnect power to the unit.
2 . Remove the siphon cup and cap.
3 . Remove the four screws securing the dis-
© 1998 Maytag Corporation
upper and lower clips holding the air dome
hose. This reduces the potential for noise.
rear hole in the top cover. Route toward
the pressure switch and secure the hose
to the pressure switch.
Siphon Cap
Linkage
Siphon Cup
Dispenser Bottom
Figure 6-4
penser bezel and assembly to the top
cover.
SECTION 6. WATER CARRYING COMPONENTS
Wax Motors
Dispenser
Top
Rotary
Nozzle
6-3