Error Displays - Panasonic AVCCAM AG-HMC151E Operating Instructions Manual

Screen displays (continued)
■
S
SD CARD FORMAT?
YES NO
Do you wish to format the SD Memory Card
now? Yes/No
SET DATE AND TIME
Set the date and time.
■
T
THE CLIP IS PROTECTED.
PLEASE CANCEL PROTECTION.
The clip is protected. Please cancel the
protection.
THE RECORDING IS STOPPED
(OVER THE LIMITATION)
Recording will stop. (Continuous recording for 12
hours)
THE TC MODE IS CHANGED TO "NDF"
NDF is selected as the TC MODE setting. (Only
when SYSTEM FREQ is set to 59.9 Hz)
THIS BATTERY CANNOT BE USED.
This battery cannot be used.
THIS CARD CANNOT RECORD IN VIDEO
MODE.
The card cannot be used for video recording.
THUMBNAIL DATA ERROR IS DETECTED.
An error has been detected in the thumbnail
information.
■
U
UNABLE TO FORMAT.
The card cannot be formatted.
■
W
WRITE PROTECT
The card is write-protected.
80

Error displays

The following messages are displayed when
an error has occurred in the camera or the SD
Memory Card. If the problem is not solved by
switching the power off and back on again,
either change the card in accordance with the
instructions displayed, or consult the place of
purchase.
■
C
CANNOT RECORD
Displayed when an error has occurred during
recording.
■
R
REC WARNING
Displayed when an error has occurred during
recording. Start the recording again. If the
message appears again, please consult the
place of purchase.
• Please switch the power off if the message
continues to appear.
• Please try inserting a different card if the
message appears again after restarting
recording.
■
S
SYSTEM ERROR
TURN POWER OFF
Displayed when an error has occurred in the
system. Switch the power off and back on again.
• If this error is displayed when accessing the
SD Memory Card, such as when deleting a
clip, the SD Memory Card may be damaged.
Please replace it with a new SD Memory
Card.
• If this error is displayed when repairing the
SD Memory Card, please use the AVCCAM
Restorer content repair software (Page 33).
■
W
WARNING
Displayed when an error has occurred with the
camera itself. Start the recording again.
FOCUS NG (error with focus operation)
PSD NG (error with jitter detection)