Table of Contents
Advertisement
DISPLAY SET
(The boldface settings in the table below indicate the settings at your purchase.)
8 SUPERIMPOSE
OFF
AUTO
8 GREY BACK
OFF
ON
8 DIMMER
BRIGHT
DIMMED1
DIMMED2
OFF
8 POWER SAVE
OFF
ON
8 ON SCREEN LANGUAGE
You can select the modes of indications superimposed on the TV screen.
OFF:
To turn off superimposed indications.
AUTO:
To superimpose operational indications for approximately five
seconds just after the corresponding operation.
NOTES:
When you use this unit as the source player for editing, be sure to set "SUPERIMPOSE"
to "OFF" before starting. (
When you select "AUTO", during playback, the operation mode indicators may be
disturbed depending on the type of disc being used.
When this function is set to "ON", the TV screen becomes all grey when
receiving a channel not in use.
NOTE:
When you want to receive an unstable channel with poor signals, set this function to
"OFF".
You can change the brightness of the front display panel.
BRIGHT:
Normally select this.
DIMMED1/DIMMED2:
To change the brightness level. (Blue lamp on the front display panel
become dimmer.)
OFF:
To dim the front display panel. (Blue lamp on the front display panel
is turned off.)
NOTE:
It is impossible to turn off the light of the front display completely. When "BRIGHT" or
"DIMMED1" is selected, the brightness level will be same as "DIMMED1" after the unit is
turned off. When "DIMMED2" or "OFF" is selected, the brightness level will be same as
"DIMMED2" after the unit is turned off.
When this function is set to "ON", you can reduce the power consumption
while the unit is turned off.
NOTES:
During Power Save mode —
— the front display panel will be turned off.
— the Just Clock function (
Power Save does not work when —
— the unit is in the Timer mode.
— the unit's power is turned off after timer-recording or Instant Timer Recording.
— the Automatic Satellite Programme Recording mode is engaged. (
— "L-2 SELECT" is set to "DECODER", "SAT VIDEO" or "SAT S-VIDEO". (
It takes some time for the unit to complete initialisation after you turn on unit power,
with "WAKE UP" blinking on the front display panel.
This unit offers you the choice to view on-screen messages in 10 different
languages. Though Auto Set Up selects the language automatically (
you can change the language setting manually as required.
For details, refer to "On-screen Language Set" (
pg. 81, "Edit To Or From Another Recorder")
pg. 104) does not work.
pg. 24).
95
EN
pg. 63)
pg. 83)
pg. 19),
Advertisement
Table of Contents
