Other Problems - Samsung M267x series User Manual

Wireless network setup
2 Check the printer port's IP address from your computer.
a Click the Windows Start menu.
• For Windows 8, from
b For Windows XP/Server 2003, select Printer and Faxes.
• For Windows Server 2008/Vista, select
and Sound > Printers.
• For Windows 7/8, select
• For Windows Server 2008 R2, select
Devices and Printers.
c Right-click your machine.
d For Windows XP/2003/2008/Vista, press Properties.
For Windows 7/8 and Windows Server 2008 R2, from context menus,
select the Printer properties.
If Printer properties item has ► mark, you can select other printer
drivers connected with selected printer.
e Click Port tab.
f Click Configure Port... button.
g Check if Printer Name or IP Address: is the IP address on the network
configuration Sheet.
3 Change the printer port's IP address if it is different from the network
information report's.
If you want to use the software installation CD to change the port IP,
Connect to a network printer. Then reconnect the IP address.
- For a Static network environment
The machine uses the static address when the computer is configured
to static address.
For example,
Charms, select Search > Settings.
Control Panel > Hardware
Control Panel > Devices and
Control Panel > Hardware >
If the computer's network information is as shown below:
▪
IP address: 169.254.133.42
▪
Subnet Mask: 255.255.0.0
Then the machine's network information should be as below:
▪
IP address: 169.254.133.43
Printers.
▪
Subnet Mask: 255.255.0.0 (Use the computer's subnet mask.)
▪
Gateway: 169.254.133.1

Other problems

If problems occur while using the machine on a network, check the following:
For information on the access point (or wireless router), refer to its own
user's guide.
• You cannot enable wired and wireless networks at the same time.
• Your computer, access point (or wireless router), or machine may not be
turned on.
• Check the wireless reception around the machine. If the router is far from
the machine or there is an obstacle, you might have difficulty receiving the
signal.
• Cycle the power for the access point (or wireless router), machine, and
computer. Sometimes cycling the power can recover network
communication.
2. Using a Network-Connected Machine
191