Temperature Range; Temperature Display; Temperature Display Brightness - Miele F 9052 i Operating And Installation Instructions

If you have adjusted the temperature,
wait for approx. 6 hours if the
appliance is not very full and for
approx. 24 hours if the appliance is
full before checking the temperature
display as it will take this long for the
display to give an accurate reading. If,
after this time, the temperature is still
too high or too low, you will need to
adjust it again.

Temperature range

The temperature can be adjusted from:
-14 °C to -28 °C
The ambient temperature in the room
and the installation location can affect
the time it takes for the appliance to
reach the lowest temperature. If the
ambient temperature is too high, the
appliance may not reach the lowest
temperature.

Temperature display

During normal operation, the
temperature display on the control
panel shows the temperature in the
warmest part of the appliance.
If the temperature is not within the
range that the appliance is able to
display (below 0 °C), bars will flash in
the temperature display.
The temperature display will flash if
– a different temperature is being set,
– the temperature in the appliance has
risen by several degrees, indicating
that the appliance is warming up too
much.
The correct temperature
This loss of coldness is no cause for
concern in the following circumstances:
– when the door has been left open for
a while, e.g. for removing or storing a
large amount of food,
– when fresh food is being frozen.
However, if the temperature in the
freezer section remains above -18 °C
for a long time, check that the frozen
food has not started to defrost. If it has
started thawing, check that the food is
safe to use and if it is, use it as quickly
as possible.

Temperature display brightness

The appliance is supplied with the
brightness of the temperature display
set as low as possible. However, if the
door is opened, a setting changed or if
the alarm is sounding, the temperature
display will appear much brighter.
The level of brightness can be
adjusted:
^ Press and hold the SuperFreeze
button for approx. 5 seconds.
The SuperFreeze indicator light flashes
;
and a flashes in the temperature
display.
15