Software Info; Factory Reset; Faq And Recommendations - Lyngdorf Audio TDAI-2170 Owner's Manual

5.8 Software info

Lists the software versions the TDAI-2170 is using. Refer to www.lyngdorf.com for the latest software.
To update the TDAI-2170:
1. Save the new software on a USB drive that came with the TDAI-2170.
2. Insert USB into the "SW Update" connector on the back of the TDAI-2170.
3. Turn off the TDAI-2170 at the main switch on the back.
4. Hold down the standby button on the front and turn on the main switch on the back.
5. Release the standby button and the TDAI-2170 will update the software.

5.9 Factory reset

Restores the system to the default factory settings.
Warning: All user preference settings, system data, and RoomPerfect™
data are lost when restoring to default settings!
52

FAQ and recommendations

What should I set my CD-players sample rate output to?
44.1 kHz. This will allow the ICC feature of the TDAI-2170 to avoid clipping of the signal.
What does the Info button on the remote do?
If you switch to an active audio input and press info on the remote, you will see the following:
Peak Level
This will show you the peak signal relative to 0 dBFS (decibels relative to full scale) and is used for
manually setting up the Input Gain or ICC (Intersample Clipping Correction). If the peak level shows
+3.4, you should set the ICC to -3.4.
When you switch to a new input or go into standby mode all measurements, including Peak Level, is
reset. As long as you stay on an input, the Peak Level data is stored and the maximum value is shown.
53