Probe Accessories; Rack Mounting Kit, Side-By-Side Mounting; H Touch-Hold Probe - Fluke 8050A Instruction Manual

I. Remove the carrying handles from both
instruments by removing the handle disc decals
and the handle mounting screws.
2. Remove the retaining screw from the rear of the
cases and separate the instruments from their
cases.
3. Install the center mounting bracket as shown in
Figure 600-4 and secure it to the mounting
panel using the nuts provided.
4. Install the clamp screw in the center mounting
bracket using the nuts and washers provided.
5. Insert the front of the instrument cases through
the openings on the back side of the mounting
panel. Make sure the cases' handle mounting
bosses are inserted into the clamp hole of the
center mounting bracket.
6. Tighten the clamp screws.
7. Install the side mounting brackets and secure
them to the front panel using the nuts provided.
MOUNTING
BRACKET
ACCESSORIES
PROBE ACCESSORIES
8. Install the handle mounting screws through the
side brackets into the handle mounting bosses.
Don't overtighten these screws.
9. Slide the instruments through the mounting
panel and into their cases. Install and tighten
the retaining screw at the rear of both cases.
600-15. PROBE ACCESSORIES
600-16. The pro be accessories are shown in Figure 600-
5 and are described in the following paragraphs. Table
600-1 contains all applicable specifications for the probes.
600-17. Touch-Hold Probe SOT-H
600-18. The 80T-H is a direct signal-through test probe
with a touch and hold feature. Touch and Hold allows
voltage, resistance, and conductance readings to be held
on the DMM display following the measurement. This
convenience also allows greater safety because the
operator can concentrate on the placement of the probe
and read the display later. The Touch and Hold feature is
activated by a push button located on the probe. Pressing
this push button holds the present reading on the DMM
display until the push button is released.
Figure 600-4. Rack Mounting Kit, Side-by-Side Mounting
600-3