Step 1: Wire Up The Heating System - Honeywell Evohome Installation Manual

Step 1: Wire up the
heating system
evohome communicates using wireless on a robust 868Mhz
signal that is unaffected by common remote controls or Wifi.
Some devices need mains power or to be connected to external
equipment and it's best to wire up these items first to simplify the
binding process later in the setup. The evohome controller will give
on screen instructions when these should be powered up.
Before you power up your evohome Controller and install
the radiator controllers, it's best to install any devices which
are mains powered or need specific installation.
In this section
Wireless Relay Box (BDR91)
Wireless Cylinder Thermostat (CS92)
Remote Access Gateway (RFG100)
Mixing Valve Controller (HM80), Underfloor Heating Controller (HCE80/HCC80),
Opentherm Bridge (R8810)
evohome Installation Guide
3
4
5
7
8