Honeywell Evohome Installation Manual page 41

Adding and replacing components in an existing system
evohome Installation Guide
Adding and replacing components in an
existing system
On the evohome Controller press and
1
hold "Settings" for 3 seconds
Press the green tick
2
To change a device in a zone press ZONE SETTINGS and
3
select the zone name To add or change an actuator
Press the application button then next and follow
4
the instructions to bind a new actuator
To change the sensor press the sensor button, select
5
the type of sensor or next and follow the instructions
to bind a sensor. If the old product is not required
in the system remember to remove the batteries at
it may still try to communicate with the system.
To change a boiler relay, system valve,
hot water component or remote gateway
Press SYSTEM DEVICE
1
Select the type of device and follow the instructions
2
to bind. If the old product is not required in the
system remember to remove the power at it may
still try to communicate with the system.
39