Defining A Custom Paper Size - Epson Stylus Photo 1290 User Manual

Roll Paper
Option

Defining a custom paper size

You can define a custom paper size. To do so, you can either create
a new paper size, or base your custom paper size on a pre-existing
paper size. Refer to the appropriate section below.
Creating a new paper size
If the appropriate paper size is not included in the Paper Size list
in the Page Setup dialog box, follow the steps below to define a
new custom paper size.
The Roll Paper Option settings are only available when
Roll Paper is selected as the Paper Source setting.
These features are not available when Sheet Feeder is
selected.
The settings are as described below.
Banner Mode:
Select this mode when you want to print multi-page data
as continuous data on the roll paper, rather than as
individual pages. When this check box is selected, the
Save roll paper check box is enabled.
Cut Sheet Mode:
Select this mode when you want to print multi-page data
as individual pages, rather than as continuous data.
When this check box is selected, the Print page frame
check box is enabled.
Save roll paper:
Select this check box when you want to save roll paper.
When this check box is selected, the blank portion of the
last page of your document is not fed through the printer.
This feature is only available when Banner Mode is
selected.
Print page frame:
Select this check box to print a line on the roll paper
between pages in a multi-page document to indicate
where the paper should be cut. This feature is useful
when it is unclear where the page breaks should be. This
feature is only available when Cut Sheet Mode is
selected.
Using the Printer Software for Macintosh
5-23