Table of Contents
Advertisement
KM 2257
Installation
Granite and marble worktops
a Worktop
b Fixing bracket (the fixing brackets
hold the lower section when the
upper section of the cooktop is
removed).
c Cooktop
d Gap
As the cooktop and worktop cut-out
may differ, the size of the gap d can
vary.
40
^ Make the worktop cut-out following
the dimensions applicable.
Remember to maintain the minimum
safety distances (See "Safety
clearances".
^ Fix the brackets b supplied.
^ Feed the cooktop connection cable
down through the cut-out in the
worktop.
^ Centre the cooktop c in the cut-out.
^ Connect the cooktop to the mains
(see "Electrical connection").
^ Connect the appliance to the gas
supply (see "Gas connection").
^ Secure the appliance at the back and
front using the fixings supplied. See
"Securing the appliance".
^ Check that the cooktop works.
^ Seal the remaining gap d with a
silicone sealant that is heat-resistant
to at least 160 °C.
Only use silicone sealant that is
specially formulated for granite and
marble, and observe the sealant
manufacturer's instructions.
Hide quick links:
Advertisement
Table of Contents
