FASTENING THE COOKTOP
Each cooktop is provided with an installation kit including brackets and screws for fastening
the cooktop to benches from 30 to 40 mm thick .
The kit includes four "F" brackets and four self-threading screws "S" (fig. 4.6).
•
Cut the unit according to the dimensions in fig. 4.1.
•
Turn the hob upside down and rest the glass side on a soft surface .
•
Spread the seal "G" around the edge of the hob (fig. 4.5).
•
Fasten the brackets "F" to the appropriate socket holes, without tightening the screws
"S" for the moment . Make sure that the tabs are mounted correctly, as shown . Rotate
the tabs so that the cooktop can be put into the cutout .
•
Put the cooktop into the cutout and position it correctly .
•
Put the brackets "F" into place; tooth "A" of the brackets should go into the hole (fig.
4 .6) .
•
Tighten screws "S" until the cooktop is completely secured to the bench .
•
Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge
of the cooktop . Take care not to damage the workbench .
Fig. 4.5
G
G
Adhesive side
Fig. 4.6
A
S
F
25