Setting Up Your Tv - JVC AV-21MT16 Instructions Manual

Setting up your TV

CAUTION
• Turn off the equipment including the TV before connecting.
1
Connecting the aerial cable.
VHF/UHF outdoor aerial
Matching aerial
adapter (supplied)
75-ohm coaxial cable (not supplied)
If you connect a VCR, connect the aerial output jack of your VCR and
the aerial jack on the TV with aerial cable. Then connect the output
jacks of your VCR and the VIDEO-1 input jacks of the TV with the
video cable (or S-VIDEO cable if available) and audio cables. For
details, see the manual of your VCR.
Rear of TV
VCR
The illustration shown is just a sample. It may not be same as your TV.
( ) 1
( ) 2
( ) 3
VHF/UHF outdoor aerial
AV-29ST16
COMPONENT
VIDEO-1
(VIDEO-2)
OUTPUT
INPUT
INPUT
S
OVER
V
V Y
/ V
L L / L
/ MONO C
B MONO
R C R R
R
2
Connecting the main plug to the AC outlet.
3
Inserting batteries into the remote control.
Insert two batteries by following the + and - polarities
and inserting the - end fi rst.
CAUTION:
Follow the cautions printed on the batteries.
Notes:
• Use AA/R6/UM-3 dry cell batteries.
• If the remote control does not work properly, fi t
new batteries. The supplied batteries are for testing,
not regular use.
4
Turn on the TV by pressing the main power button.
JVC logo appears on the screen.
JVC logo will appear on the screen again at the phase of "SETUP
TOUR RESTART?" function. Then the initial setting can be performed
according to page 8.
Note:
While in the INSTALL menu with the cursor pointing at INSTALL, pressing
the blue button will also display the JVC logo.
7