Table of Contents
Advertisement
FREQUENTLY ASKED QUESTIONS
The table below groups together the answers to the most frequently asked questions concerning your Audio system and your NaviDrive.
QUESTION
There is a difference in
For optimum sound quality, the audio settings (Volume, Bass, Treble,
sound quality between
Ambience, Loudness) can be adapted to the different sound sources,
the different audio
which may result in audible differences when changing source (radio, CD,
sources (radio, CD,
CD changer...).
CD changer...).
The CD is ejected
The CD is inserted upside down, is unplayable, does not contain any audio
automatically or is not
data or contains an audio format which the player cannot play.
played by the player.
The CD is protected by an anti-pirating protection system which is not
recognised by the audio equipment.
The CD player sound
The CD used is scratched or of poor quality.
is poor.
The audio equipment settings (bass, treble, ambiences) are unsuitable.
RESPONSE
SOLUTION
Check that the audio settings (Volume, Bass,
Treble, Ambience, Loudness) are adapted to
the sources listened to. It is advisable to set
the AUDIO functions (Bass, Treble, Front-Rear
Balance, Left-Right Balance) to the middle
position, select the musical ambience "None"
and set the loudness correction to the "Active"
position in CD mode or to the "Inactive" position
in radio mode.
- Check that the CD is inserted in the player the
right way up.
- Check the condition of the CD: the CD cannot
be played if it is too damaged.
- Check the content in the case of a recorded
CD: consult the advice in the "Audio" section.
- The audio equipment's CD player does not play
DVDs.
- Due to inadequate quality, certain recorded
CDs will not be played by the audio system.
- The CD changer does not play MP3 CDs.
Insert good quality CDs and store them in
suitable conditions.
Set the treble or bass level to 0, without selecting
an ambience.
Advertisement
Table of Contents
