Section 1. Safety Information - Jandy WaterColors LED Installation Manual

Page 4
Safety Information
Section 1.
IMPORTANT SAFETY INSTRUCTIONS PERTAINING TO A RISK OF
FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS
READ AND FOLLOW ALL INSTRUCTIONS
When installing and using this electrical equipment, basic safety precautions should always be followed, including the
following:
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION.
licensed or certified electrician in accordance with the National Electrical Code and applicable local codes and
ordinances. Improper installation will create an electrical hazard, which could result in death or serious injury to
pool or spa users, installers, or others due to electrical shock, and may also cause damage to property. Read
and follow the specific instructions below.
Before installing this underwater light, read and follow all warning notices and instructions accompanying this
light. Failure to follow safety warnings and instructions can result in severe injury, death, or property damage.
Call (707) 776-8200 for additional free copies of these instructions.
Except when the Jandy WaterColors LED Lights are installed in an area of the swimming pool that is not used
for swimming and the lens is adequately guarded to keep any person from contacting it, the light shall be
installed in or on a wall of the pool, with the top of the lens opening not less than 18 inches (457 mm) below the
normal water level of the pool
ATTENTION INSTALLER: This manual contains important information about the
installation, operation and safe use of this product. This information should be given to the
owner/operator of this equipment.
The Jandy WaterColors LED Lights are intended for installation in fresh water and salt water swimming pools.
It is important to ensure that the wet niches in which the lights are installed are intended for their appropriate
application, either fresh water or salt water pools.
WARNING
WARNING
CAUTION
NOTICE
SAVE THESE INSTRUCTIONS
This underwater light must be installed by a