Installing An Input Adaptor - Sony Trimaster PVM-L2300 Operation Manual

Installing an Input
Adaptor
Each input adaptor can be installed in any input option slot
on the side panel.
Caution
When you install the following input adaptors to this
equipment, use those with the serial numbers given below.
• BKM-220D with serial number 2100001 or higher
• BKM-229X with serial number 2200001 or higher
• BKM-243HS with serial number 2108355 or higher
BKM-220D: This equipment may not meet the
requirements of the electromagnetic interference standard
if designated input adaptors are not installed.
BKM-229X: This equipment may not work correctly or
you may not be satisfied with their performance if
designated input adaptors are not installed.
BKM-243HS: This equipment may not meet the
requirements of the electromagnetic interference standard
or work correctly, or you may not be satisfied with the
performance if designated input adaptors are not installed.
Note
Turn off the MAIN POWER switch of the monitor and
disconnect the AC power cord before installing or
removing adaptors.
1
Loosen two screws and remove the cover of an input
option slot on the side panel of the monitor.
Cover of an
input option slot
18

Installing an Input Adaptor

Make sure the MAIN
POWER switch is turned off,
and disconnect the AC
power cord.
2
Insert the adaptor facing the board as shown below.
3
Push the adaptor in until it is firmly fit into the
connector inside the monitor, then tighten the two
screws to secure the adaptor.
For Dual-link operation
Two BKM-243HS or BKM-244CC input adaptors are
required. Install the input adaptors in OPTION 1 and 2
option slots, or OPTION 3 and 4 option slots.
To connect the cable
Input the Link A signal to OPTION 1 or 3, and the Link B
signal to OPTION 2 or 4.
Connect the cable to the same input number (both INPUT
1 or both INPUT 2) of the input adaptors installed in
OPTION 1 and 2 option slots, or OPTION 3 and 4 option
slots.
Board