One RJ-45 connector
Safety wire tie point
Slots for wall mounting
Clips for mounting on a suspended ceiling T-bar
Lock port for Kensington® style Security Lock
The AP650 access point has one RJ-45 connector supporting an 10/100/1000 Ethernet port and requires
802.3af-compliant power from an external source.
The AP650 Access Point comes in both single and dual radio versions both supporting 802.11a/b/g/n.
The Access Point contains runtime firmware which enables the unit to boot after either a power up or a watchdog
reset. The runtime firmware on the Access Point and the firmware downloaded from the controller can be updated
via the Ethernet interface from the controller.
When operating in a Gigabit Ethernet environment CAT-5e or CAT-6 cable
is required for Gigabit operation.
AP650 Access Point