Power; Adjusting Volume; Changing Channels; Display 1 - JVC AV 27020 User Manual

POWER

Press the P button on the remote control or the TV front panel. The power lamp will glow red.
OWER
(On the AV-27020 and AV-27015 the On Timer lamp will glow red.)
Make sure that the TV/CATV switch is set to TV (RM-C340 and RM-C345 only). Switch to CATV
only if you plan to operate a cable box. If you switch to CATV you will not be able to operate the
TV functions with the remote, only the cable box functions!
To turn the power off, press the P
The On Timer lamp will glow red when the On/Off Timer is set, even when the TV power is off.

ADJUSTING VOLUME

Use the V –/+ buttons (
1
OLUME
button to lower the volume. Press the V
Press the M
2
UTING
previous volume level, simply press the M

CHANGING CHANNELS

1
10 key direct access.
Press the numbers on the remote's 10 key pad. For single-digit channel numbers press 0 then the
number. For channels above 100, press the 100+ button plus the 2-digit number.
2
C –/+ button (
HANNEL
Press the C –/+ button, it will scan the channels in order.
HANNEL
NOTE: After you operate the Auto Tuner Setup (page 13), all of the blank, or empty, channels will be
removed from scanning so that there is no noise or channel snow when you scan, only active channels.
3
Regular Return.
Press and release the R
(game #1). Then, select another channel (game #2) with the 10 key pad and push the R
button to flip directly back and forth.
4
Return+ .
Press and hold down the R
PROGRAMMED !" will appear and you can scan as you wish with the C
R + again and you will go back to the Return+ channel you programmed.
ETURN
To cancel the Return+ channel, press and hold down the R
and the message, "RETURN CHANNEL CANCELLED !" appears.
Pressing any number key or turning the TV off will also cancel a Return+ channel.
G E T T I N G S T A R T E D
button again. The power lamp will go out.
OWER
) on the front panel or remote control. Use the V
VOLUME 13
|||||||
button to instantly turn the volume off to zero. To restore the volume to the
).
+ button to return to the previous channel. First, select a channel
ETURN
+ button for three seconds. The message, "RETURN CHANNEL
ETURN
+ button ( ) raise the volume.
OLUME
-------------------
button again.
UTING
ETURN
-/+ button. Press
HANNEL
+ button for another three seconds
9
– ( )
OLUME
+
ETURN