Download Print this page

Motorola APX O2 User Manual: Figure 2-59. Disconnecting The Speaker Connector; Figure 2-60. Reattaching The Control Head

Hide thumbs

Advertisement

Standard Configurations Speaker
4. Put the control head face down on a clean, flat surface to avoid damaging it. Do not touch the
o-ring on the back housing.
5. Carefully disconnect the speaker connector from the circuit board as shown in
6. Reattach the front housing assembly to the back housing assembly as shown in
Make sure that the flex is returned to its original position and that the o-ring on the back
housing assembly is not pinched.
7. Secure the front housing assembly back to the back housing assembly with four new screws
using the Torx T-20 bit as shown in
6878215A01

Figure 2-59. Disconnecting the Speaker Connector

Figure 2-60. Reattaching the Control Head

Figure
2-60. Apply 9 in. lbs. torque for each screw.
2-45
Figure
2-59.
Figure
2-60.

Advertisement

   Related Manuals for Motorola APX O2

This manual also for:

Apx o5, Apx o7, Apx o3, Apx o9

Comments to this Manuals

Symbols: 0
Latest comments: