Figure 2-52. Mini-Uhf Connector Tool (As Shown On Mid Power); Figure 2-53. Mini-Uhf Connector Tool (100W Radios Only) - Motorola ASTRO APX O2 User Manual

Standard Configurations Antenna Installation
4. Slide the collar back against the flange. Insert the antenna cable plug's pin fully into the radio
jack, but do not engage the threads.
5. Ensure that the plug's and jack's interlocking features are fully seated. Check this by grasping
the crimp on the cable jack, rotating the cable, and noting any movement. If the features are
seated correctly, there should be NO movement.
6. Finger-tighten the antenna cable plug's collar onto the radio's jack.
7. Give a final tug, by hand, to the collar, and retighten by hand as firmly as possible.
8. Slip the mini-UHF connector tool over the coaxial cable, using the gap between the tool's legs
(see Figure
straight legs of the tool firmly together between your thumb and index finger and turn
clockwise (as shown) to tighten the collar. It should take 1/4 turn or less. When you feel the
tool slipping on the collar, the connection has been properly tightened. The tool can also be
used to loosen a tight collar.
NOTE: DO NOT use pliers or any other device to grip the tightening tool. It has been designed to
allow you to achieve the proper torque on the collar without overtightening. Overtightening the
collar can damage the connector and the radio.

Figure 2-52. Mini-UHF Connector Tool (As Shown on Mid Power)

6878215A01
2-52). Then, slide the tool up onto the plug's knurled collar. Squeeze the two
HLN6695_
HLN6695_

Figure 2-53. Mini-UHF Connector Tool (100W Radios Only)

(1) Squeeze
Firmly Together
(1) Squeeze
Firmly Together
2-41