Download Print this page

Motorola APX O2 User Manual: 2.2.2.4 Cable Installation; 2.2.2.5 Setting The Initial Control Head Id; Figure 2-33. Apx Mobile O5 Control Head Front View; Figure 2-34. Radio Display With Current Control Head Id

Hide thumbs

Advertisement

Standard Configurations Radio Mounting
Part Number

2.2.2.4 Cable Installation

Route the cables where they are protected from pinching, sharp edges or crushing. Use grommets in
any holes where the cable passes through metal panels.
components are connected. It is not recommended to route cabling or wiring inside the wheel wells
of a vehicle.

2.2.2.5 Setting the Initial Control Head ID

The Front Panel Programming (FPP) mode allows you to define which control head in a Multi Control
Head system becomes control head number 1-4.
Set the control head ID number for each attached head the first time Multi Control Head is used.
1. Press the power button to power off the radio.
2. Press and hold left-most menu and the orange button on the control head simultaneously.
3. Press the power button to power on the control head. The head will power on into FPP mode
and display the current control head ID number:
4. Turn the Mode knob to change the control head's ID number.
6878215A01

Table 2-8. Ignition Interface Cables

HLN6863_
Cable, M.A.P. 26pin with Only Ignition and SPK
PMLN4959_
Cable, Y-Splitter with DB-25 and M.A.P. Interface
Power Button
Left-most
Menu Button

Figure 2-33. APX Mobile O5 Control Head Front View

Figure 2-34. Radio Display with Current Control Head ID

Description
Figure 2-19
O5
CH ID#
1
shows how the cables and
Emergency
Button
2-29

Advertisement

   Related Manuals for Motorola APX O2

This manual also for:

Apx o5, Apx o7, Apx o3, Apx o9

Comments to this Manuals

Symbols: 0
Latest comments: