Chapter 6 Finishing The Installation; Cable Connection; O2 Control Head; O3 Control Head - Motorola ASTRO APX O2 User Manual

Chapter 6 Finishing the Installation

6.1

Cable Connection

6.1.1

O2 Control Head

Perform the following if it has not been previously done:
1. Remove the control head from its mounthing trunnion. Plug the radio's CAN cable into the
proper location on the back of the control head (see
Chapter 2). The connectors "click" when snapped into place. The control head model can
have the microphone plugged into the lower left corner of the control head front panel.
2. Connect the plug from the speaker lead to the mating connector coming out of the power
cable.
3. Plug the VIP connector into the correct location on the back of the control head.
4. Connect the CAN cable to the proper location on the transceiver.
NOTE: Connector-protective covers are provided with the radio. They should be used for added
environmental robustness.
Be sure the control head and microphone PTT switches are OFF. Install the 15-amp fuse in
the radio power cable fuseholder and the 3- or 4-amp fuse(s) in the ignition sense cable
fuseholder(s).
Turn the radio ON at the control head and verify proper operation of all controls and indicators.
Radio operation in some installations require turning on the ignition sense. Perform a
complete operational check of the radio.
Dress the control and power cables out of the way to prevent damage (pull any excess cable
into the trunk area) securing with clamps and tie wraps where necessary.
6.1.2

O3 Control Head

Perform the following if it has not been previously done:
1. Unplug the CAN coiled cable connector on the Transceiver Interface. Plug in the connector
again. A "click" sound should be heard. Ensure location of CAN connector is correct
(i.e. J800L or J800R) on the transceiver interface.
Connect the plug from the speaker lead to the mating connector of either J2 or J626
(refer cabling diagram for detail).
6.1.3

O5 Control Head

Perform the following if it has not been previously done:
1. Remove the control head from its mounting trunnion. Plug the radio's CAN cable into the
proper location on the back of the control head (see
Chapter 2). The connectors "click" when snapped into place. The control head model can
have the microphone plugged into the lower left corner of the control head front panel.
2. Connect the plug from the speaker lead to the mating connector coming out of the power
cable.
Figure 2-28 and Figure 2-30
Figure 2-28 and Figure 2-30
in
in