Download Print this page

Motorola APX O2 User Manual: 5.12 Installing The Emergency Switch Option; 5.13 Installing The External Alarm Relay Option; 5.14 Installing The Headset Accessory; Figure 5-18. Motorcycle Wiring Harness Rework

Hide thumbs

Advertisement

Motorcycle Radio Installation Installing the Emergency Switch Option

5.12 Installing the Emergency Switch Option

Use the two-conductor, green/black cable which has as one end terminated with two contacts (part
number 3080221P02) and which is supplied with this W688 Motorcycle Emergency Push Button.
Disconnect the emergency switch shorting plug from the accessory cable. Replace the shorting wire
of the shorting plug with the terminated end of the green/black emergency cable. Reconnect the plug
to the accessory cable.

5.13 Installing the External Alarm Relay Option

The motorcycle radio is offered with only one optional relay connection. If both horn and lights are
required, wire a second relay coil parallel to the first relay. Use the two-conductor green/black cable
which has one end terminated with two contacts (part number 3080221P02) and which is supplied
with this W116 Motorcycle Alarm Relay Option. Insert the contacts into positions 3 and 4 of the
emergency shorting plug of the accessory cable. Refer to

5.14 Installing the Headset Accessory

A six-position connector on the accessory cable has been made available for connecting a headset
accessory. Headset manufacturers should be consulted for compatibility with the motorcycle radio
prior to purchase and installation of the headset. To install, disconnect the headset shorting plug.
Remove the headset shorting wire from the headset shorting plug. Terminate the contacts provided
to the applicable wires of the headset cable. Insert the terminated wires into the headset shorting
plug per the contact positions illustrated in the typical headset schematic found in this manual.
Reconnect the terminated headset shorting plug to the accessory cable.
When upgrading from an APX mobile radio, the existing headset cable HLN6890 requires these two
pins to be swapped (see
3080010R04.
26
Remove from Pin 1
(VI P OU T 1 )
Insert into Pin 22
(Monitor)
21
Rework for Handlebar HUB operation when
upgrading existing cable HLN6890.
6878215A01
Figure
5-18). The other motorcycle headset cable with this pin change is
7
20
13
J2, BACK OF RADIO
8
14
1

Figure 5-18. Motorcycle Wiring Harness Rework

Figure
5-23.
SPK +
1
3
GND
AUX_PTT
5
(Female-Pins)
5-25
SPK -
2
4
VIP OUT 1
6
AUX_MIC

Advertisement

   Related Manuals for Motorola APX O2

This manual also for:

Apx o5, Apx o7, Apx o3, Apx o9

Comments to this Manuals

Symbols: 0
Latest comments: