Canon Elura 50 User Manual page 97

4. Locate the point where you want to start audio dubbing, then press
the PAUSE button.
• You can use the playback buttons on the body of the camcorder or the special
playback functions on the wireless controller in the same way as in playback
mode.
• The camcorder becomes set to playback pause mode.
5. Press the AUDIO DUB. button.
• AUDIO DUB. and
6. Press the PAUSE button (and start play on the other audio device
if AUDIO IN).
• Audio dubbing starts.
• If MIC. IN, direct your voice into the microphone.
• changes to
7. When you get to the point where you want to stop dubbing, press
the STOP button (and then stop play on the other audio device if
AUDIO IN).
• Audio dubbing stops and AUDIO DUB. disappears from the display.
• The camcorder returns to stop mode.
• You can also set zero set memory (
audio dubbing, then every time you return to that position, audio dubbing
will stop.
• If instead of pressing STOP you press PAUSE, the camcorder will return to
the playback pause mode.
Notes:
• You cannot use the DV terminal while adding sound.
• You might want to adjust the audio mix (
added sound.
• There may be a loss of sound quality if you add sound to a tape recorded on a
camcorder other than the ELURA50.
• After adding sound 3 or more times to the same place on a tape, there may be
some loss in sound quality.
appear on the display.
.
84) at the place you want to stop
98) when playing back a tape with
E
97