Download Print this page

Advertisement

■ FUSER UNIT FAILURE
Step
Harness connection failure
1
between fuser unit connector and
eject sensor PCB ASSY
2
Fuser unit failure
3
LVPS PCB failure
4
Toner LED PCB failure
5
Main PCB failure
CAUTION :
This problem will be cleared if turning off the power switch and turn on it again, then leave
the machine power on for 15 minutes.
In the case of LED model, turn the power on while pressing the [Go] button, when the front
cover is open. And check that Back cover/Toner/Drum/Paper LEDs light up, and then
release the [Go] button. Check that all LEDs go off and press the [Go] button twice, and
then this problem may be cleared by that press the [Go] button once again after all LEDs
light up.
This operation will melt the fuser unit if the heater is hot. Leave the machine for 15
minutes and perform it after cooling down sufficiently.
■ LASER UNIT FAILURE
Laser diode failure/Polygon motor failure
Step
Laser unit harness connection
1
failure
FG harness ASSY connection
2
failure
3
Laser unit failure
4
Main PCB failure
■ MAIN MOTOR FAILURE
Step
Main motor harness connection
1
failure
Main motor becomes abnormal
2
load.
3
Main motor failure
4
LVPS PCB failure
5
Main PCB failure
Cause
Cause
Cause
Replace the drive sub ASSY.
3-24
Remedy
Check the harness connection between
fuser unit connector and eject sensor PCB
ASSY and connect it.
Replace fuser unit.
Replace the LVPS PCB unit.
Replace the toner LED PCB ASSY.
Replace the main PCB ASSY.
Remedy
Check the two harness connections of the
laser unit and reconnect them.
Check the FG harness ASSY connection
between the laser unit and main PCB
ASSY. Then reconnect it.
Replace the laser unit.
Replace the main PCB ASSY.
Remedy
Check the harness connection of the main
motor and reconnect it.
Remove the motor load cause to turn the
each gears.
Replace the LVPS PCB unit.
Replace the main PCB ASSY.
Confidential

Advertisement

Table Of Contents

Troubleshooting

   Also See for Konica Minolta Bizhub 20p

   Related Manuals for Konica Minolta Bizhub 20p

Comments to this Manuals

Symbols: 0
Latest comments: