Konica Minolta Bizhub 20p Service Manual page 254

Hide thumbs Also See for Bizhub 20p:
Table of Contents

Advertisement

<Function>
Functions of each "Service Mode".
9)
Factory Inspection Mode
This mode checks the operation of each sensor and solenoid to check the point with the
malfunction, when repair the machine.
• The machine goes into the inspection mode by a special operation when the power is
turned on.
• In the inspection mode, check that the Status LED or a switch is changed (from ON to
OFF, or from OFF to ON).
<Sensor Inspection Check Procedure>
• Check sensors.
Manually activate the sensors and the actuators listed below, and verify that the
Status LED is lit.
(When the state is changed continuously, the Status LED keeps blinking.)
(Regist front sensor, Regist rear sensor, Paper eject sensor, New toner sensor, Front
cover sensor, PE sensor, Edge sensor, MP PE sensor, Duplex tray sensor)
* The toner sensor is unsupported.
Front cover sensor
Frame L
Paper eject sensor
(Relay rear PCB)
Duplex tray
sensor
New toner sensor
(Relay front PCB)
Toner sensor PCB
(Light reception) Un supported
Regist rear sensor
High-voltage PS PCB
Fig. 6-1
6-7
Chute
Frame R
Regist front sensor
Toner LED PCB
(Light emission)
Un supported
Regist frame
Paper feed frame
MP PE sensor
PE EG sensor
PE sensor
Edge sensor
Confidential

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents