Download  Print this page

Advertisement

Press the [Go] button twice.
Press the [Go] button again depending on the necessary number of times after check
that Toner/Drum/Paper LEDs are lighted.
Press the [Go] button
Once
Twice
Three times
Four times
Five times
Six times
Seven times
Eight times
Nine times
Ten times
More than 11 times
CAUTION;
• Each mode starts 2 seconds after pressing the [Go] button.
• If the [Go] button is pressed, the Status LED is lighted. If the [Go] button is
released, the LED is out.
17) Printing for Maintenance
* Start printing when close the front cover.
18) Maintenance + Test pattern with margin frame
Printing (Duplex/LongBind)
* Start printing when close the front cover.
19) Network Config Printing
* Start printing when close the front cover.
20) Sleep Mode Setting (ON/OFF)
* Check that all LEDs are lighted for one second.
Ineffective
Ineffective
21) Developer Roller Counter Reset 3
(For the toner cartridge)
* Check that all LEDs are lighted for one second.
22)Fixed USB Speed Mode
23) USB Speed Indication (ON/OFF)
24) Sleep Mode Indication (OFF/Dimmed)
Go back to Normal State
6-6
Mode
Confidential

Advertisement

Chapters

Troubleshooting

   Also See for Konica Minolta Bizhub 20p

   Related Manuals for Konica Minolta Bizhub 20p

Comments to this Manuals

Symbols: 0
Latest comments: