Download Print this page

Advertisement

1.2

User Mode

Basically, user mode should be accessed by service personnel only. Assist as needed, when
the telephone support, end users can operate under service personnel order.
<Procedure>
(1) Check that the front cover is closed.
(2) Turn ON the power switch while holding down the [Go] button.
(3) After all LEDs on the panel are lit, only the Status LED goes out while holding down [Go]
button.
(4) Release the [Go] button and check that all LEDs are off.
(5) Press the [Go] button depending on the necessary number of times.
(If the [Go] button is pressed, the Status LED is lighted. If the [Go] button is released,
the LED is out.)
Press the [Go] button
Once
Twice
Three times
Four times
Five times
Six times
Seven times
Eight times
Nine times
Ten times
11 times
12 times
More than 13 times
CAUTION;
• Each mode starts 2 seconds after pressing the [Go] button.
• If the [Go] button is pressed, the Status LED is lighted. If the [Go] button is
released, the LED is out.
1) Test Sample Page
2) Print Fonts
3) 1push Printing Recovery Mode
4) Hex Dump Mode
1) Test Sample Page
5) Network Reset (APIPA: ON)
1) Test Sample Page
6) Factory Reset
1) Test Sample Page
7) Settings Reset
1) Test Sample Page
8) PCB ONLY Mode
1) Test Sample Page
6-3
Mode
Confidential

Advertisement

Table Of Contents

Troubleshooting

   Also See for Konica Minolta Bizhub 20p

   Related Manuals for Konica Minolta Bizhub 20p

Comments to this Manuals

Symbols: 0
Latest comments: