Download Print this page

Konica Minolta Bizhub 20p Service Manual: Control Panel; List Of Service Support Functions

Hide thumbs

Advertisement

1. CONTROL PANEL

Various modes can be used if the power switch is set to ON while the [Go] button is held.
There are two types of modes: User Mode and Service Mode. Three types of lamp display
are used to indicate that present setting.
• Back cover/Toner/Drum/Paper LEDs are lighted at the same time to show that transfer to
the specified mode or another level are completed.
• Status LED is lighted to show that the [Go] button is held when the mode or function is
selected. Status LED is out if the [Go] button is not held.
• All LEDs are lighted for 1 second at the same time to show that initialization or change of
set values is completed.
1.1
List of service support functions
Front
Press the [Go] button
cover
when sifting the mode
Close
0 times
Open
Once
Press the [Go] button
when selecting the
function
Once
1) Test Sample Page
Twice
2) Print Fonts
Three times
3) 1push Printing Recovery
Four times
4) Hex Dump Mode
Five times
1) Test Sample Page
Six times
5) Network Reset (APIPA: ON)
Seven times
1) Test Sample Page
Eight times
6) Factory Reset
Nine times
1) Test Sample Page
Ten times
7) Settings Reset
11 times
1) Test Sample Page
12 times
8) PCB ONLY Mode
More than 13 times
1) Test Sample Page
Once
9) Factory Inspection Mode
Twice
10) Continuous Grid Pattern
Three times
11) Fixing Unit Test Print
Four times
12) NV-RAM Value Dump
Five times
13) RAM Check
Six times
14) QA Test print
Seven times
15) DX setting (ON/OFF)
Eight times
16) Paper Size Setting (A4/
Nine times
8) PCB ONLY Mode
More than ten times Go back to Normal State
6-1
Function
Mode
Print Mode
Mode
Letter)
Refer
to:
6-4
6-4
6-4
6-4
6-4
6-4
6-4
6-4
6-4
6-4
6-4
6-4
6-4
6-7
6-8
6-8
6-8
6-8
6-8
6-8
6-9
6-4
Confidential

Advertisement

Table Of Contents

Troubleshooting

   Also See for Konica Minolta Bizhub 20p

   Related Manuals for Konica Minolta Bizhub 20p

Comments to this Manuals

Symbols: 0
Latest comments: