Download Print this page

Advertisement

8.8

Main PCB

(1) Remove the four cup S M3x6 SR Taptite screws, remove the FG harness and then
remove the Shield cover.
Taptite, cup S M3x6 SR
Taptite, cup S M3x6 SR
(2) Disconnect the five or six connectors and six flat cables from the Main PCB.
Note:
• After disconnecting the flat cable(s), check that each cable is not damaged at its
end or short-circuited.
• When connecting the flat cable(s), do not insert it at an angle. After insertion, check
that the cable is not at an angle.
Duplex solenoid connector
Relay rear (Flat cable)
Assembling Note:
• When assembling the Main PCB, ensure to place the Ferrite Core correctly.
FG harness
LD harness (Flat cable)
Main PCB
LT connector
Shield cover
Fig. 5-34
Panel PCB connector
Relay front (Flat cable)
Polygon motor (Flat cable)
LVPS PCB connector
Ferrite core
Main motor (Flat cable)
HVPS PCB (Flat cable)
FAN connector
Fig. 5-35
5-34
Confidential

Advertisement

Table Of Contents

Troubleshooting

   Also See for Konica Minolta Bizhub 20p

   Related Manuals for Konica Minolta Bizhub 20p

Comments to this Manuals

Symbols: 0
Latest comments: