Download Print this page

Konica Minolta Bizhub 20p Service Manual: Installing Procedure

Hide thumbs

Advertisement

< Installing Procedure >
(1) Secure the Laser unit with the six cup S M3x6 Taptite screws.
(2) Put the Flat cable (LD harness connector) through the Core.
(3) Put the Flat cable (Polygon motor connector) through the Core and Protective film.
(Refer to
"6. HARNESS ROUTING" in Chapter
(4) Connect the two Flat cables to the Main PCB.
Note :
• When connecting flat cable(s), do not insert them at an angle. After insertion, check
that the cables are not at an angle.
Taptite, cup S M3x6
LD harness connector
(Flat cable)
Main PCB
Polygon motor connecter
(Flat cable)
Laser unit
Core
Laser unit
Protective film
Fig. 4-18
4-13
5.)
LD harness connector
(Flat cable)
Taptite, cup S M3x6
core
Protective film
Polygon motor connector
(Flat cable)
<Main PCB>
Confidential

Advertisement

Chapters

Troubleshooting

   Also See for Konica Minolta Bizhub 20p

   Related Manuals for Konica Minolta Bizhub 20p

Comments to this Manuals

Symbols: 0
Latest comments: