Set Lock Code - JVC 0104KGI-II-IM User Manual

Set Lock Code

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes
preset with a lock code of "0000". You may change the code to any four-digit number you wish.
To change the lock code, follow the steps below.
Press the M
To SET LOCK CODE
π †
è
To operate (lock icon
Press Z
ERO
The first digit will be highlighted
è
To select the number
To move to the next digit
π †
Continue to follow these directions for all four numbers
To FINISH
π †
è
To save settings and exit
(your lock code is now set)
Press the E
When a viewer attempts to watch a blocked channel, this message appears:
The channel will remain blocked until the correct lock code is entered (see above for information
on setting your lock code).
Notes:
• After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.
button
ENU
appears)
to access the lock code
button when finished
XIT
���� ����������� �������
���� ������ �������
������ ����� ���� ���� ��
�� ��� ��� �� ������ ���
��� � � � �
Initial Setup
�
� � � � � � � � � � � �
� � � � � � � � � � �
� � � � � � � �
� � � � � �
� � � � � � � �
� � � � � � � � �
� � � �
� � � � � �
� � � �
31