JVC TM-H150CG Instructions Manual page 9

Controls and Features
Input Card (option)
7 SDI Input Card (IF-C21SDG/IF-C51SDG)
The EMBEDDED AUDIO signal is acceptable. (IF-C51SDG is also equipped with an
AUDIO LEVEL METER function.)
SWITCHED
OUT 1
2
IN1
E.AUDIO
SDI
IN2
3
AUDIO
4
MONITOR
OUT
(This illustration is IF-C21SDG.)
7 Acceptable signal formats when installed
on this monitor:
525/60i, 625/50i,
EMBEDDED AUDIO (8ch)
IMPORTANT
• Do not use any other input card than the input cards listed on pages 7 and 8.
Using other input cards may cause malfunction or damage the monitor. Such malfunction or damage caused by using other
input cards cannot be warranted.
• If any equipment is not connected to a bridged output (OUT) terminal, be sure not to connect any cords to the bridged output
(OUT) terminal. Connecting a cord to a bridged output (OUT) terminal will cause the terminating resistance switch to open (auto
terminate function).
• When making a bridge connection, connect the input (IN) and output (OUT) terminals on the monitor to separate video
components.
(For example, if both the input (IN) and output (OUT) terminals are connected to the same VCR, resonance may occur except
during playback. This is caused by that the same video signal circulates between the VCR and the monitor. This is not a
malfunction.)
8
(cont'd)
1
SWITCHED OUT terminal
Output (OUT) terminal for the re-clocked signal. The input signal from
the input terminal currently selected (IN1 or IN2) is re-clocked and
output from this terminal.
NOTES:
• No signal is output from the SWITCHED OUT terminal when the main power is turned
off.
• Even when the input signal is switched from the SDI Input Card, the SWITCHED OUT
terminal still outputs the IN1 or IN2 re-clocked signal which is selected last time.
The re-clocked signal from IN1 is output from the SWITCHED OUT terminal when the
monitor is in stand-by mode.
2
D1 SDI and EMBEDDED AUDIO signal input terminals
Accepts the SMPTE259M D1 SDI signal. Also accepts the
EMBEDDED AUDIO signal whose sampling frequency is 48 kHz
and the channel range is 1 to 8.
To select IN1 : Press the INPUT SELECT C button.
To select IN2: Press the INPUT SELECT D button.
\ To select the EMBEDDED AUDIO channels and to set the AUDIO LEVEL METER
function (only for IF-C51SDG), set the DIP switches on the input card correctly. For
details, refer to the instruction manual supplied with the input card.
3
Connection terminal
Attach to the connection terminal of the input card slot on the
monitor.
4
Audio signal output terminal
Outputs the analog audio signal after decoding the EMBEDDED
AUDIO signal. The input signal from the input terminal currently
selected (IN1 or IN2) is output from this terminal.
\ This terminal outputs the same audio signal as the audio sound output from the
speaker.
NOTES:
• No signal is output from the audio signal output terminal when the monitor is in stand-
by mode.
• Even when the input signal is switched from the SDI Input Card, this terminal still
outputs the audio signal from the IN1 or IN2 which is selected last time.
(cont'd)